The equipment and devices required in a hot rolling factory are as follows in the order of the process:
Preheated furnace: The preheated furnace does the work of heating the metal before rolling. This furnace has a conveyor-like system that moves the metal along the furnace and gradually raises its temperature uniformly. Ejector: The ejector works to separate and transfer metal Heated towards the rolling process.
Descaler or scale separator: During the process of heating the metal, scales may be formed on the surface of the metal and separated from it. This device performs the work of separating the shells.
Rolling stand: The main work of rolling is done in this section. The rolling rollers are located in this stand, and the shamshal gets a thinner cross-section by passing through them and is so-called rolled.
Brick stand: After rolling in the previous step, which is done using horizontal rollers, in this step, vertical rollers are used to ensure the uniformity of the sides and all parts of the sheet.
Swinger: As it is clear from the name of this device, it performs the work of bending the produced sheet. This work is done with small rollers.
Thickness gauge device: Finally, the produced sheet is thickness measured by this device to determine its exact dimensions.
Cooling device: The cooling device reduces the temperature of the produced sheet with special methods and so-called cools it.
Cutting device or scissors:< /b> This machine cuts the two ends of the sheet.
Packing machine: It is used to weigh and then pack the produced sheet.